Questions & Answers for: wiper motor runs wipers don

...like the breaker didn't do its job and the wiper motor fried. My guess is it needs replacing. If you open the hood with the wipers on, can you hear the wiper motor running even if they aren't

wiper motor for my 2001 chevy venture. The wipers are not parking fully down, and the intermittent setting parks the wipers about half way up until it is ready to wipe again. the reason i am replacing

wiper motor, under a plastic cover. The motor should be located, under the hood, on the firewall, very near to one of the wiper arms. Simply, unplug the wiring harness to the motor and remove the 3 or

...WIPER MOTOR I had this same problem. The wiper blades would extend too far and hit the edge of the car, or they wouldn't extend far enough and only wipe about 3/4 of the windshield. The problem was a ...

...wiper motor is not making a good ground therefore the wipers are not coming to the exact parking position. By pulling on them you pass that position and they begin to operate correctly. Thank you, ...

Wiper motor buzzing, wipers not working. Is the motor shot or a lose connection? These use a module bolted onto the front of the motor under the hood, on the driver's side. It's held on by 3 torx head

the wiper arm or trans. Try grabbing one of the wipers and try to move it buy hand, if it moves freely that's your proplem. The other reason could be the wiring for the wiper motor or the motor itself

...wiper motor. To reconnect the linkage, first remove the wiped arms, the remove the wiped cowl. The wiper cowl bolts are located under the hood and screws through the spaces in the cowl. Reconnect ...

...work. But radio and windshield wipers don't. 1995 chevy Z 71 truck runs good and all outside lights work. But radio and windshield wipers don't. First thing to do is check your

wiper motor is controlled by the SJB. The SJB supplies power to the rear wiper motor from the integrated rear wiper relay. The SJB will activate the relay when all of the following conditions are met: