Questions & Answers for: Ford Bronco II vapor lock fuel injection

Question about 1987 Bronco II

1 Answer

87 bronco 2 fuel injecter harness on an 87 bronco 2 for the fuel injecters there is a common wire and two pulse wires,does one plse wire feed the injecters on the pass. side and the other on the ...

Ad

Question about 1986 Bronco II

1 Answer

wont idle at first it was only at a stop light but now it will die all of the time starts and runs for just a little bit then starts running rough an then dies sounds like a fuel problem. I would ...

Ad

where is the fuel pump on a 1986 ford bronco II v-6 fuel injected engine the pump is on the top of the fuel tank and goes down inside the tank from there. you have to drop the tank to get to the fuel ...

...pressure switch also,cleaned whole fuel system both pumps work fine possible bad injector wires or bad ecm being obd 1 the computer only runs the fuel injection parts not everything else like ...

Vapor lock? On cold start it works great and idles just fine but as it heats, the engine starts choking and soon dies out. If this is vapor lock, how do I repair it. Thanks Kyle sounds like the reason

Question about 1988 Bronco II

1 Answer

vapor locking this Ford Bronco II. One reason is that early model used an open fuel system and none injectors. With the alcohol additive will low the boiling point of the fuel causing it to boil away;

Question about 1988 Bronco II

2 Answers

...vapor lock and technically it is...... the fuel pump in the gas tank is getting tired and needs replaced.......keeping a full tank can ward off the problem at times but eventually the in tank fuel ...

Question about 1988 Bronco II

1 Answer

Fuel vapor canister or charcoal canister. Your purge solenoid may be inoperable. When engine is running the solenoid energizes to purge the canister of vapors into a line going to the intake manifold.

Question about 1990 Bronco II

1 Answer

...fuel injection on the 2.9 L V-6 they manufactured them with two fuel pumps.Pump number one is located in the fuel tank on a hanger complete with fuel gauge sending unit.This pump is used for ...

...the ignition switch on the column it just will not stay running without starting fluid does anybody have any idea what it could be carb --vapor locked --fuel filter ---switch over valve ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...