Questions & Answers for: Symphonic what type of solder

tape wont eject wont eject tape. power cuts off after about 10 sec. it didnt do this until i put in a tape Veri8fy that the belt on the side of the VCR mechanism is intact. If it is, then check that ...

my cble connection is broke how can i replace it my cable connection is broke how can i replace it In most cases, this requires soldering a new RF connector into place. Otherwise, the tuner will need ...

must take out and reinsert batteries each time I try to use clicker. Sometimes have to repeat for 10 minutes to turn on. You may have loose connection where you put the batteries. If you open the ...

Turn on and it goes off. Bad Crt Tv better buy new one most of the times its bad soldering in the old tvs or blown caps in your case it can be Fbt transistor or alot other things the first step is to ...

...solder bridge short in between its terminals and see the effect. If it does not helps, replace the capacitors used in that section. Replace them all with same type. There will be 5 or 6 of them. If ...

symphonic WF27F4 (an old tv??) How to restore the video which is sometimes just a horizontal bar or line, and if you hit a good wallop it may recover the picture for an hour, a day, or a week until it

picture colors keep fading U have tools like a soldering iron and roll of solders?Fixed it by resoldering the tv video board pins connecttions sockets pins between tv video board and the CRT-(tv tube)

...terminals. Resolder all the picture tube socket solder terminals also. Till the problem perists, its video processor IC [Chroma IC] is faulty, and should be replaced with same type and number.

antenna hook up I HAVE AN ANTENNA HOOKED UP TO THE SYMPHONIC TV BUT I AM GETTING NOT CHANNELS I WONDER WHAT WRONG ANTENNA FINE JUST NEE TV!! If you are using an indoor Antenna: 1- the most probable ...

the screen flickers while watching it Most likely the capacitors are blown. They can be replaced, but soldering and assembly skills would be required.