...shaft positioning sensor is bad because you say when you disconnected the battery and reconnected it it wouldnt even rev up thats a tell tell sign for the sensor because when you disconnected the ...
...20 mph engine rev goes over 3 even 4 and noise is loud. please tell me what to do. thanks tazul That would be the turbine speed sensor.............not a cheap fix at around £450 with main ...
my 1999 clk 320 suddenly will not shift out of 3rd gear, its been going good for 184000 miles and all service has been done by a mercedes mechanic sounds like the transmission is in limp home mode ...
...Turbine Speed Sensor input shaft no signal & trans won't shift from 2nd gear started out being intermittent now stuck in 2nd. You will need your transmission tested or checked out The Turbine ...
...That is a bad crank shaft sensor. I had the same problem with my clk 430. The sensor malfunctions after it heats up then will function again once cooled down. Easy fix, 1 bolt but is in a tight
Question about 1998 CLK
...shaft sensor is aligned properly on re-assembly as misalignment will result in a non-start and you might doubt your own work. Don't worry about timing belt failure or misalignment on the twin cam ...
my merceds clk 320 1999 wont pick up speed i turn it on and i have it in park and press on the gas but i wont pick up speed and it just does a crazy noise like it want to pick up give it a full tune ...
it wont pick up speed even when its park When i press my foot on the gas the car gradually picks up speed! It sounds like something is clogged and is keeping my car from going! it sounds like it needs
where is speed sencer on clk240 auto 2003 where is speed on 209 auto On the transmission case.
in the light front or back and the fuse blows when +/- connect from water I had the same problem 88mbzW124. My problem was the crank shaft position sensor. I replaced it and now it cranks as it should
Usually answered in minutes!
231 Questions
161 Questions
58 Questions
41 Questions
23 Questions
