20 Most Recent 1999 Mercedes-Benz CLK Questions & Answers


look at antenna wires make sure every thing is in contact.if all is good.sound like problems in the sound amplifier.in radio.

1999... | Answered on Nov 03, 2018


I have had a similar problem quite a few years ago. You don't mention the model or year of your vehicle. It could be a relay that is on the firewall just below or behind the firewall in engine compartment in front of driver's side of the car. It took a really savvy MB mechanic an hour to locate and fix after 2 months in other shops, including an MB dealership. Mine was a 1988 560SEL that had that problem. After that was fixed, it worked perfectly for another 5 years - at which time I sold the car.
I hope this helps...

1999... | Answered on Oct 24, 2017


If the airbag light is on something in the system is broken. Go to AutoZone or similar and have them scan the airbag system for codes. My guess would be a faulty seat sensor or a faulty seat belt sensor

1999... | Answered on Jun 16, 2017


Check the owners manual.

1999... | Answered on Feb 15, 2017


MB doesn't use a reset switch (AKA Inertia switch) for the fuel pump

1999... | Answered on Jun 27, 2016


on most cars, you need to change the neutral safety switch. this car has a neutral parking position sensor, you can find it for v6 not v8, it also fits a saab 9-3. it is the same thing, a different style. however, check the transmission fluid level and troublecodes for p07xxs. reset the code and use the transmission dipstick by dorman add lucas auto trans fluid, not stop slip to the fill line. most of the time it's not the solenoid, but the auto trans plate, overfilling the fluid can cause it to trigger a check engine light, and the fluid leaking onto it can cause it to be permanently damaged, it's more than $400 for the part. lucas works in the 722.xx transmissions, most , all, clks 99-2002, just make sure the tranny model isn't a 238. i like it better than atf 134. However, these parts are very heat sensitive. fill the trans fluid, reset the troublecodes, do a general motos drive cycle from obdii.com if it doesn't drive good after four times, change the neutral safety switch. :)

1999... | Answered on Nov 29, 2015


under the hood, the fuse box on the left side rear back corner, it clips up from the front and has two catch hooks on it. the fuse is number 23 and it is a blue 15 amp ATC big blade fuse, get a variety pack for $4.99 at your local auto parts store. :) the numbers for the fuses are beside each slot.

1999... | Answered on Feb 26, 2015


Well, first, the battery is not dead. You could have a poor electrical connection somewhere between the battery, starter, ignition switch, or another component of your start circuit, or possibly a failing starter solenoid, or ignition switch. Some electrical testing will be necessary to find the problem. A quick check the next time it won't crank over, is to pull the starter solenoid wire off and check for power on the wire when key is held in crank position. If power then, probably a failing starter solenoid. If no power there, then you have to diagnose the start circuit back through the ignition switch to the battery. Are all your battery and ground connections clean and tight? Starter connections? Use process of elimination, use care, and you'll find the problem.

1999... | Answered on Feb 24, 2015


brake switch needs replacement.

1999... | Answered on Oct 05, 2014


I purchased a MB CLK 320 and set the radio frequency and successfully put the freq in memory, however, the radio blinks tthe freq. Is this normal or do I have to enter another key to stop the radio from blinking?
Ed
Massachusetts

1999... | Answered on Sep 25, 2014


Yourself at home ?

No experience ?

Watch the Video

1999... | Answered on Aug 14, 2014


Here is how I adjusted my parking brakes:
Jack rear of car up and place on jackstands (safety first) Take the rear wheel off, observe how freely rotor turns while turning by hand.
Align one of the lug bolt holes with the adjusting wheel inside. Mine was at alignied with one of the holes at the 2 o'clock position. Hold a flashlight into the hole to see what the tooth of the wheel inside looks like and insert a flat blade screwdriverthrough the hole and catch beetween 2 teeth.Start moving the screwdriver handle upward (tip of the screwdriver moving downward)to turn the adjusting wheel clockwise, do about 2 turns and turn the rotor to see if there is a slight resistance turning the rotors and adjust more or less depending on the resistance.You only want some slight resistance to much and it will drag all the time and wear out your parking brake pads prematurely

1999... | Answered on Aug 05, 2014

Not finding what you are looking for?
1999 Mercedes-Benz CLK Logo

278 questions posted

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85111 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

CLK Mercedes-Benz

  • CLK Mercedes-Benz

Most Popular Question

need check fuse lighter in car find

  • Cars & Trucks
Loading...