Questions & Answers for: Buick turbine input shaft speed sensor

Question about 2002 Rendezvous

1 Answer

...Input wheel speed sensors looked at for performance. If you have access to a scantool, scan for the codes and you can reset the code. Be advised that resetting a code is at best, a temporary fix. I ...

Ad

Question about 2003 LeSabre

2 Answers

Input/Turbine Speed Sensor Circuit No Signal. This code shows because the computer isn't getting any signal from the sensor. Either the sensor is dead or there's a circuit issue (bad wiring, etc). The

Ad

...i start. CODE PO717 IS - A/T INPUT SHAFT SPEED SENSOR LOW INPUT CONDITIONS.YOUR INPUT SHAFT SPEED SENSOR COULD BE DEFECTIVE.CHANGE FLUID + FILTER IF IT HAVE NOT BEEN CHANGED IN A LONG PERIOD OF

...input/turbine speed sensor on a 2006 buick rendezvous 3.5 v6? I t is the valvebody which is located inside the side cover on the drivers side of the transaxle, this is not a diy job. Can i roll the ...

...input speed sensor signal.. what does all this mean You might need to replace your sensor. Also, replace your alternator belts before you change sensor. The drag on speed is caused by the "check ...

...buick century input speed sensor location i need to change the input sensor is in side the transmission yes or no The speed sensor is not really inside the transmission, it is on the outside of

input speed sensor for 2006 buick Lucerne The vss, if that's what your talking about, should be in the half-shaft housing. I'm not sure which side, at the moment. My info says right side of transaxle,

...turbine shaft, an AC signal is induced in the input speed sensor. Higher vehicle speeds induce a higher frequency and voltage at the sensor. There is a fixed air gap between the sensor and the teeth ...

...input speed sensor was in front of transmission. Any idea were to look.or any pictures. Would help.i found output. The vehicle speed sensor is located on the transaxle output shaft, on the passenger ...

...input speed sensor? I need to change both sensors where are they and how can I change them ? The output and input speed sensors on a 2011 Buick Lucerne are located on the transmission. The output ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

2002 Buick Rendezvous
2002 Buick Rendezvous

1,091 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...