Questions & Answers for: Mercury trunk solenoid

...trunk can that fry my relay button or is it a seperate issue?) You may have a drain on the battery as well as trying to start the engine. You could try jumping a feed to the starter solenoid and see ...

Ad

solenoid in trunk lid may need to be adjusted or replaced, or the same with the latch itself. If no sound from solenoid: There should be 3 wires to the button: ground (black), 12v supply from ignition

Ad

...of the vehicle in the area of the trunk. It will be a black rectangular box with a few rubber lines and electrical connections going to it. The vent solenoid can be found next to the

Question about 2000 Grand Marquis

1 Answer

...trunk that was tripped. Reset the button and now the car will not crank. The voltage drops from 12.8 to 8. I replaced the battery, starter and ignition switch. Is there a starter solenoid on the ...

Trunk solenoid opens but wont close until I press the release repeatingly the trunk opens ok but wont close until I press the open button several times until the solenoid doesn't click No need

Question about 2008 Grand Marquis

1 Answer

...trunk lock wont work, no power... no interior lights, no clock no radio, no a/c..tried to start...nothing..not even a click of a solenoid... dead.. checked battery voltage it was over 12v.... put my ...

trunk why? Still working though right? Many of the relay systems use an electric solenoid motor to generate the release...usually located at the connection tab as closing...also will help you find for

to open it, it happen's either with inside button or remote Your trunk release uses a solenoid to power the release switch...a noise is common when engaging this...is this a new noise, or just noticed

...trunk release is like a solenoid. You should check the power wire going to it to see if the wire is working when you press the trunk release. If the wire shows power when you press the release, the ...

solenoid location on 1999 mercury grand martize located on car This located under the trunk and is covered by a steel plate that's bolted in you will see the emissions hoses coming out on the side the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Mercury Cougar
1999 Mercury Cougar

1,305 Questions

2001 Mercury Sable
2001 Mercury Sable

689 Questions

2000 Mercury Sable
2000 Mercury Sable

627 Questions

2002 Mercury Sable
2002 Mercury Sable

646 Questions

2000 Mercury Cougar
2000 Mercury Cougar

630 Questions

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...