...transfer belt. No error message, just poor quality printing. OPC belts appear to need changing fairly often - I am on my third. Take it out and have a look (note that it is light sensitive, do it ...
I get a Change opc belt alarm I get a Change OPC Belt Alarm opc belt is the transfer belt.belt is worned out.
...changing are packed with the new drum, and the belt unit is the transfer belt that also wears out and needs changing periodically. The instructions are packed with that also and not hard to
...belt, and look around inside for loose paper. I didn't find any loose paper. I found that simply turning the power off and on again will remove the error message and let me print again (so far)] ...
...belt unit temperature sensor and registration relay PCB, and the one between the registration relay PCB and engine PCB. Then reconnect them. Step 2: Cause: Transfer HVPS PCB unit failure Remedy: ...
...transfer belt. trying a different toner cartridge may fix the problem but it may not. Most likely given the cost of repair, replacement may be your best option. thank you, Lee check your tuner, it ...
...transfer belt. One roller is driven by a cog and this goes fine. The other roller has a tensioner and this roller is making all the noise. While the noise is really loud and annoying - it is ...
belt unit check Belt unit is the transfer belt that transfers the image to the drum or to the page. Pull the transfer belt and re-seat it again.
...Transfer Belt (the glossy black plastic thing beneath where the drum carriage is normally) using the handle available. Put this down also on a flat surface carful not to damage the plastic sheet or ...
Usually answered in minutes!
1,072 Questions
495 Questions
422 Questions
377 Questions
249 Questions