...torque wrench at your disposal to perform this procedure. Hondas go forever if you take care of them, a torque wrench is a small investment (and some auto parts stores will loan/rent them to you). ...
...one on each side of each pipe connection). Used washers are already crushed and so require more torque to seal. Usually just tightening the hex fitting more will make the seal. Always use two ...
...torque value while holding the damper shaft (A) with a hex wrench (B). Remove the trunk side trim panel. Install the rear wheel. NOTE: Before installing the wheel, clean the mating surface of the ...
...tight should i make the axle nut after fitting new rear wheel bearing assembly if i don't have a torque wrench tighten the nut down and spin the hub to set the bearings and then back it of a 1/4 ...
how do i remove a front axle spindle nut off my 2001 honda civic lx Unstake the nut and turn left, a impact wrench is needed, be sure to torque the nut when putting it back together, 135 ft lbs.
...bolts to 25ft lbs. 2nd: all bolts to 50 ft lbs 3: retighten all bolts to 50ft lbs. the last stage is to tighten all bolts 1/4 turn more. do not use torque wrench for the last 1/4 turn hope this ...
...gun, or a chain strap wrench to hold the pulley while loosening the bolt. That bolt is usually torqued to almost 200 foot
torque on it to get it free. I use an Impact wrench but you can use a long "Cheater bar" about 3 feet in length or they sell a hammer driven impact that fits sockets you can use. You put the socket on
...torque wrench and just nip it up with a ring spanner and a two finger pull this will give it about 15lb which is about right ,you cannot do this sort of thing with a torque wrench as the threads can ...
on the threads, screw them in by hand to ensure they are not cross threaded, then if you are using an inch lb torque wrench it will be 156 inch lbs. or if a ft lb torque wrench would be 15-16 foot lbs
Usually answered in minutes!
1,130 Questions
1,041 Questions
758 Questions
811 Questions
722 Questions
