Questions & Answers for: tire tube

Question about 850 8 Speed Cassette 11-32t Mountain Bike

3 Answers

the capacity of the tire to accept the tube when it's inflated so I always aim somewhat to the small side for tubes (they stretch). In fact, to reduce rolling mass you can run smaller or thinner tubes

Ad

Question about 850 8 Speed Cassette 11-32t Mountain Bike

1 Answer

...tube up into tire(carefull not to let it get twisted), now put cap back on tube so you don't loose the filler, now work your way around with your fingers to push tire back into rim, you may need to ...

Ad

tire and tube together as you turn the tire in the direction needed to rotate the inner tube back into alignment with the hole in the rim. Now refill the inner tube to 5 lbs less than the max pressure

Question about 12" Roadster Tricycle

1 Answer

...tube should fit a 12" tire. There are other factors to consider though and the mentioned site explains them all very well. When you replace the tube make sure you use plastic or synthetic tire tools ...

...tube and the tire the rest of the way. Basic tire removing tools are neccesary such as tire spoons and rim protectors. check the rim for sharp points as well as any debris that might have punctured ...

Question about 2007 DR-Z 400 SM

2 Answers

...tire or tube on rim. where do I start for trying to put the new tube and tire on? its somewhat hard to explain in words check this video out http://www.youtube.com/watch?v=u7KJK_rl9cU also most bike ...

...tire and buy a tube that is the same size. Most of them are 26x1.75-2.00, but it could be 24 or even 29 depending on the size of the bike. The tube usually has the size printed right on it. If not go ...

Question about Boulevard FS

1 Answer

...Remember to rub your fingers on the inside of the tire before installing a new tube to make sure you have removed the offending thorn, or else you are going to have another flat, sure as

...Tire Inner Tube? unbolt wheel and using tire spoons or the handle of flat ware [as long as its strong enough to not bend ]place inbetween the tire bead and rim and pry up and over rim now either use ...

...tire and tube but looks like the tire, tube and rim are all connected? I have never seen anything like this. Is this normal? Check this out Glenn.. How To Change Mountain Bike Tire and Inner ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Cycling Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66980 Answers

Kardoc

Level 3 Expert

7503 Answers

Tony Parsons
Tony Parsons

Level 3 Expert

6405 Answers

Are you a Cycling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...