...similar problems, and jpossible solutions. Thanks Gary if the car was fine before you replaced the timming belt then it sounds like its still 1 tooth out either 1 forward or 1 back. hope that helps ...
...cam at 12 o clock crank at 6 o clock marks in rear timming cover twin cam cams marks face each other 3 & 9 o clock crank at about 6 o clock mark in cover all marks are visible on gears and ...
Question about 2000 Lanos
...timming marks on cams face each other 3 and 9 o clock crank mark at about 6 o clock mark in cover and sump auto adjuster arrow should be in v mark to set this requires turning water pump by loosening ...
...but nothing since. What am I missing??? did you turn over any gears while belt was off to align timming marks? if so did you encounter a resistance and forced the gear over with a bit more than ...
timming marks located and what would not make it start Timing mark is located at the cranshaft cover and it needs to be alligned with the mark on the crankshaft pulley. What would not make it start is
...mark more than exhaust. if you have tensioner that needs retaining pin in when installing you fit belt while aligning timming marks fit tensioner as last spot to feed belt on with retaining pin in ...
...positions both lobes on number 4 cylinder face each other (point towards centre of engine)when timming marks on cam gears are lined ...
2000 daewoo leganza has fuel pressure, has spark, new timming belt, marks are right on, trys to start but don't check sensors
...mark diagram for a 2000 daewoo nubira cdx here are the timming marks the other important thing is to Rotate the automatic tensioner hex?key tab anti-clockwise until the adjust arm pointer of the ...
TIMMING MARK ON THE CAM SHAFTS PLEASE If the timing belt stripped out chances are a valve in the interference engine was bent. These engine are called interference engines because they are designed in
Usually answered in minutes!
554 Questions
540 Questions
436 Questions
424 Questions
410 Questions