Questions & Answers for: Toyota tighten belt

...and the belt will tighten up. After you get the belt where you want it, tighten the lock bolt back up. The lock bolt has an unusual head on it. It will look different from the others in that

...to the alternator belt...alternaotr belt looks tight..thanks You should see a slider bracket on the P/S pump. Loosen the upper and lower bolts and with a pry bar, shift the pump to tighten the

tighten that belt becasue it also runs the water pump and if u over tighten it and cause the pump bearing to fail and an water pump is an major repair on these engines because the water pump is behind

...belt side engine mount, tighten bolts to specification in sequence. See Fig. 6 . On MR2, tighten engine Hope this helps, don't forget to rate. Lazaruselite I can show u how to do it or email u ...

...Look st you A/C compressor. There should be a way to tighten the belt. If this does not help you might need to replace the belt. I might would replace belt and tighten. Hope this

...will need to replace your belt tensioner in order for your belt to tighten.another reason could be that it is time to replace your serpentine belt.hope this info helps.take care and good luck, ...

...belt and lightly tighten bolt. Remove: Timing belt lower cover [7]. Crankshaft sprocket guide washer [9]. Timing belt. Tensioner pulley. Installation Installation 1. Check tensioner pulley for smooth ...

...mount before tightening to specification. 14.On Camry, when installing control rod and bracket on strut tower and right (timing belt side engine mount, tighten bolts to specification in

tighten the belt. This one is not as easy as the other two which have tensioners. This belt is tensioned by the alternator itself. I've found adjusting it to not be a lot of fun ... the tricky part is

...t over tighten cause the water pump uses the belt too.will be it and it will leak or bearing will go bad. One or more pulley(s) are frozen, Most likely it is the AC clutch. You have to turn all ...