Questions & Answers for: Cadence tighten belt

...tighten the belt. this is normally done with an allen key, look at the end of the treadmill as if you were to walk onto it, and there should be a plastic cover on each side. look in here and you ...

tighten my belt ..it goes from one side to the other First check that the treadmill is level. Then adjust levelers if possible. Most treadmills will have a bolt at the rear of the tail roller one each

tighten the belt, start by locating the two bolts that adjust the rear roller (one on each side of the unit in the back). Run the unit at about 3 mph. Tighten the bolts a 1/4 turn at a time. Make sure

tighten the belt, start by locating the two bolts that adjust the rear roller (one on each side of the unit in the back). Run the unit at about 3 mph. Tighten the bolts a 1/4 turn at a time. Make sure

...way down and stops completely. The walking belt slows when walked on the walking belt maybe overtightened, treadmill performance may decrease and the walking belt may become damaged or the ...

...belt is going towards is the side you will need to tighten. The best way to do it is to turn it a half of a turn then try and run the machine. if that does not help then loosen the other side a half ...

...on it? You will need to tighten the belt, you can do this by accesing the panel at the side and depending on the model use a screwdriver to tighten it. Any further questions please feel free to

...tighten (clockwise) both bolts 1 turn. Retry the machine. If there is no noticeable difference, remove the hood and see if the rubber belt is slipping. If so tighten the belt by adjusting the

...try using heavy duty star washer instead of the flat one.take the side foot panel off you will see the bolt that you would tighten for tension,to the w/belt this mite help in it not lossening

...belt seems tight enough, tried to tighten 1/4 turn, still not moving properly. Treadmill is a Weslo Cadence 450, bought a few years ago. Thanks lift the sides of the w/belt the hieght should be 2-3 ...