Questions & Answers for: Harley Davidson FLHR Road king how to test relays

...with a small wire plugged into a connector at the top of the plate. Disconnect the wire and stick a test light or a volt meter into the wire side of the plug, not the starter side. Turn on the switch ...

...test to see which wire power from the start button was coming from. Usually most relays have a schematic drawn right on them. Look at the relay and find the "coil" connections. Using either a test ...

...You should feel the relay click. If it does click but the starter does not engage, you need to test the voltage coming out of the relay. To test the output of the relay, look at the end of your ...

...the cranking procedure with a volt meter hooked up. If it does fall below 9 volts do a proper load test on the battery and replace if necessary. Second replace the starter relay cheap $6 and make ...

...Severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary. 11. Check battery terminals for damage or corrosion, check the battery cables at

... that you begin with a fully charged battery 12.5 volts or better and be able to pass a proper load test, and the usual suspects are: 1. Battery terminals have loose or corroded connections. 2. ...

..."OFF" position. 3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary. 4. Check the battery terminals for damage or corrosion check the battery cables ...

..."OFF" position. 3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary. 4. Check the battery terminals for damage or corrosion check the battery cables ...

...battery,when I try to jump start jumpers get hot,bad battery or starter problem. Hi, Dave before testing any electrical component in the Starter Circuit it is "IMPERATIVE" that you have a fully ...