...trouble code f 10 when I use kenmore oven 790.78573400 The "F10" error code caused by the runaway temperature. The first thing I would check is the resistance across the oven temperature probe
What is an F-24 error code? f24 is out-of-range reading from temperature sensor, if you take the panel work off you find the sensor, sometimes a wire rattles out of its socket so the sensor cant sense
Question about HE2 Plus Front Load Washer
...screen the I have to hit stop start over, what is f24? The F-24 error code indicates that the water temperature sensor reading is out of range (below 23 degrees F or above 217 degrees F). This is ...
Error code F 10 during broiling. model #790.78649601 The "F10" error code caused by the runaway temperature. The first thing to check is the resistance across the oven temperature probe (aka oven ...
i haVE A MODEL NO 47465 WHEN OVEN IS ON AFTER 3 MIN THE CODE F_2 COMES ON This means that the oven temperature sensor is open. Check oven temperature sensor, should be ~1100 ohms at room temperature. ...
...all on the low heat settings? Any ideas? If the dryer is running then the thermal fuse is okay. The temperature is controlled by three parts. There is the operating thermostat which is on the blower ...
Question about 79012 / 79014 / 79019 Gas Kitchen Range
...allow bacteria to grow. It's essential to guard against this by adjusting your refrigerator temperature when necessary. Read below for how to do it. 1 Measure the temperature of you ...
Question about 79012 / 79014 / 79019 Gas Kitchen Range
let set 24 hours for temp to stabilize, keep lowering until right temp/environment is achieved. The temperature of refrigerators should not be allowed to exceed 41 degrees F as this will contribute to
Question about 79012 / 79014 / 79019 Gas Kitchen Range
Where is the temperature control located for kenmore coldspot refrigerator model 106.51139210 There are two temperature sensors (one in the refrigerator and one in the freezer). The refrigerator ...
Question about 79012 / 79014 / 79019 Gas Kitchen Range
...instructions to "set the control control", but no set cold control is visible. Found this The temperature is factory preset to provide satisfactory food storage temperatures. However, the ...
Usually answered in minutes!
608 Questions
156 Questions
75 Questions
57 Questions
50 Questions