Questions & Answers for: Chevrolet sun sensor

...sensor is located? Well , If the fluid is dark, burnt , or has metal or dark clutch material. The transmission has a burnt up clutches ,the sun shell in most cases with this transmission is the cause ...

...sun load sensor. Pull the windshield garnish molding from the A-pillar in order to disengage the retaining tabs and clips. Remove the windshield garnish molding from the A-pillar. Daytime Running ...

...sensor(other reasons) spark plugs and wires appear fine.Put on sun machine and it's running from Lean to Rich.Was 1.25 before the o2 sensor which failed the test and with the new sensor 1.28 so I'm ...

...de una chevrolet blazer 2001 Sorry to tell you this but I had the same problem. The reverse sun shell has gone out of the transmission. The transmission must be rebuilt or replaced. This is a ...

...the Ignition switch going open when heated up. And wiring would be next. Also the sun load sensor could be going bad if you are talking about the auto head lamps and not when you turn them on

...Sun is up and it warms up, will start all day. Distributor changed about a year ago. Sounds like a coil intermittent. Try a new coil or if you want to test it you can connect an ohmeter to the wires ...

...sometimes near 32F). It would usually start after some cranking once the air warmed up a bit or the sun was shining on the car for a while (really!). Ran a pint of SeaFoam injector cleaner through it ...

sensor hole. It should not be any higher than about 2 psi at 3000 rpm. I have seen this problem several times now on these vans and I'm almost certain this is your problem. Hope this helps, Dave http:

...sun for an hour or so, it starts if I pump the gas pedal? that to me says tune up!!!! make sure you get plugs wires, pcv valve, rotor, cap and definetly a fuel filter. good luck i would suspect the ...

...the wrong bulbs. These lights operate from a sensor located in the center of the dash and use the suns ultra violet rays to go from daytime lights to headlights. Make sure this sensor is not ...