Questions & Answers for: subaru legacy clutch adjustment

legacy gt 92 single turbo clutch adjustment how do i adjust the hydraulic clutch on my 92 gt legacy Only clutch adjustment is at the pedal as they are hydraulic. Clutch may be worn, cheers

Ad

1999 subaru legacy outback with manual trans won't go into gear? clutch seems to be working fine ok maybe it needs adjustments or it may need some trans repairs

Ad

subaru legacy I have adjusted the cable in and out doesn't seem to make much difference the flywheel may be shiny and slippery. Also the clutch may be very worn down. You will probably need to replace

subaru Legacy wagon ....But says the clutch slips in secound gear...I believe the clutch needs replaced..ASKING SHOULD I EVEN CONSIDER BUYING AND ASKING FOR LESS, LIKE SAY $2700 AND FIXX THE CLUTCH OR

Question about 1999 Legacy

1 Answer

subaru legacy that is in good working order except the clutch seems to be slipping sometimes. when i bought the car it had been stood for 8 months with no or little use. any suggestions? may just need

Question about 1991 Legacy

1 Answer

...Subaru Liberty, I noticed that the rear brakes stuck on when I come to a stop, when I released the clutch, the brakes released, can you tell me if this is a safety feature on these cars or were the ...

car acts like its not changing well catching the gears i think the clutch needs to be adjusted it wont go over hills or anything Generally a grossly mis-adjusted clutch indicates wear to the clutch ...

...Subaru Legacy GT Estate car, petrol r/h drive (UK), 2L twin turbo that was imported into UK. clutch pedal began to stick in the pressed down position occasionally so I had to flick it up with my toe ...

Question about 2005 Legacy

1 Answer

...my car is a standard and it wont shift into reverse most of the time A bad clutch or an out of adjustment clutch will do that. Otherwise it's most likely something gone wrong with the

...Subaru legacy If you mean the release arm that goes into the transmission, removal of the transmission is required. If you mean the rod from the slave cylinder to the release arm, undo the two bolts ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...