Questions & Answers for: Ford strap wrench

is the thing.   Probably doesn't fit, they spin it right out.  I've put the pulley back on and put chain wrench or strap wrench around the pulley to hold the engine from turning

...i use chain wrench or strap wrench to hold pulley in place! Have a friend under the car holding a pry bar into the teeth of the flex plate (flywheel). Without a strap wrench, that's the easiest

floor and the stick goes into will unscrew, then the stick just pulls out. Hopefully, a strap wrench will grip it tight enough to get it free--otherwise a pipe wrench will do the job, but mar the ring

...expedition? this actualy takes a special wrench but can be done with a large strap wrench. you have to hold the pully from turning and turn the nut that is molded to the fan stem counter clock

...of the clutch fan with a pipe wrench. You can also get a chain strap wrench to use to hold the pulley. There is a actual tool, similar to what I described, but I haven't seen it readily available

...nut then what i use is a strap wrench with a nylon strap to remove and replace. you can find one at harbor frieght for cheap but it still will be a pain to put it back on. just part of the

wrench, then plug in the electrical connector and connect the clamp by hand. Align the fuel pump assembly with the retainer within the tank and push it into the retainer with your hands until the tabs

...wrench. Push the cable end away from the battery so it doesn't make contact during the repair. Turn the lug nuts on the right-front wheel counterclockwise until they're loose enough for hand removal, ...

...strap wrench near the base of the filter but sometimes there isn't room to swing it. I also have a strap wrench that has a square drive on it that accepts a 3/8" ratchet (or ratchet with long ...

...tool dedicated to removing the large plastic ring but I have always managed with a hammer and blunt screwdriver to get things moving and then a chain wrench, though a strap wrench might also