Question about 2000 FLHTCUI Electra Glide Ultra Classic
how to remove starter from ultra classic. engine in frame with exhaust hooked up.engine still assembled. will the primary have to be removed. battery disconnected. Yes, The first thing you do is ...
Question about 2004 FLHTCUI Electra Glide Ultra Classic
starter removal on 2004 ultra classic harley davidson starter removal on 2004 ultra classic Disconnect battery , remove the outer primary case, pull back the lock tab on the starter jackshaft, unbolt ...
how do I remove the starter on a 2004 ultra To remove the starter, first disconnect the battery. Then remove everything from the right side of the bike so that you can gain access to the starter. Go ...
Question about 2003 FLHTCUI Electra Glide Ultra Classic
How do I change my starter motor? Is there any problems I could come acrossed that I should know??? The starter motor is not that difficult to change. First disconnect the batter. Then drain the ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
how to remove starter on indian scout 2003 I'm sorry but I cannot answer your question. I don't have any knowledge of the Indian engine nor do I have any mechanical drawings of the engine. If it was ...
how do i remove a starter from aharley flht To remove the starter from an FLHT, disconnect the battery. Then drain and remove the outer primary cover. Once you have the outer primary cover off, remove
The starter on my 1991 Harley Davidson FLHTCU is bad and I need to change it, what are the steps on doing this. First, disconnect the battery. You'll need to remove the outer primary cover. Take the ...
Question about 2002 FLHTCUI Electra Glide Ultra Classic
how to you remove the starter from a 2002 harley ultra classic Pull MAXI fuse or disconnect battery.Drain primary, then remove primary cover, remove bolt from jack shaft on starter and pull of gear. ...
Question about 2002 FLHTCUI Electra Glide Ultra Classic
how to change a starter on a 2002 ultra classic harley-davidson First step would be to diconnect the battery negitive wire. Next would be to drain your clutch case oil as it will need to be removed to
Question about 2000 FLHTCUI Electra Glide Ultra Classic
exhaust pipe and side cover. NOTE: If necessary, remove Allen screw and decorative chrome cover to facilitate starter removal. 11. Remove the coupling from the starter motor output shaft, if necessary
Usually answered in minutes!
681 Questions
291 Questions
199 Questions
191 Questions
187 Questions