Questions & Answers for: Toyota Land Cruiser start button

start button, engine starts and shuts off immediately. After 3-4 attempts it remains on. The key is close by, the brake is depressed, gear is in park. Only does it after it's been parked over night or

start.checked every thing in the ignition system and its fine. but still wont fire Turn ignition to acc if you have the key and press the button on the sleeve its a hole in the sleeve with a button.If

start button on the remote box but nothing happen, if I check the info button on the remote box I get info that the engine is off. What do I wrong for be able to start my Prado with the remote starter

...button to switch to compass. The compass should start to blink. - Drive your car in a 360 degree circle until the compass stops blinking. - And that's about it. Even though this is an old question I ...

...ODO button (on off) till it reads 20.. 6.)if 15 then press it until it reads 15 again. 7.)once it reads 15 or 20 press and hold ODO reads current km travelled.. 8.)start engine and light will be

...start" button is turned on. The 80 series LC has a button next to the shifter which allows it to start in 2nd gear. If the button is not engaged then there could be a problem with the circuit, but ...

why is my shifter hard to shjft from park to any gear? The problem started a couple months ago where the release button on shifter wouldn't push in with my foot on brake, then it would the 2nd

...button in and turn the key but don't start the engine and keep holding the button for 10 ten seconds then lift your finger off the button and the number 1 should come up now this number represents ...

Start) then back to OFF. D. Remove the key from the ignition. 5. Within 3 seconds the power door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if

Start) then back to OFF. D. Remove the key from the ignition. 5. Within 3 seconds the power door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if