Questions & Answers for: size allen wrench need remove

...size alan wrench to tighten or loosen face plate . That is if you have not stripped that hole by putting the wrong tool to it. Under that plate is the 2 main screws to hold the hardware tight to the ...

...allen key of the right size... if your lucky you'll see a flathead bolt that can be loosened... then put your key only partially into the deadbolt and turn it counterclockwise and it will come out ...

kwikset deadbolt. Here's how I fixed it - on the inside of the door, take off the latch that flips the deadbolt in and out using a very small allen key. There is a round plate cover that is snapped on

...allen wrench. I can't figure out how to remove the inside faceplate or tighten the out side face plate. The inside face plate snaps on. To remove it remove the T handle and use a small flat head ...

...I tighten it up\? on the inside of the door look on the bottom of the lock cover. There should be a hole with a screw or allen head screw. Remove the screw and you can access the the rest of the

...deadbolt I bought has no template or instructions for me to holesaw the hole and install it. I need a holesaw size and hole locations sometimes the kwikset web site has templates that you can ...

what size allen wrench to remove a kwikset deadbolt http://www.doorlocksdirect.com/89926-001.html 1/8

...on the lock. I'm just assuming because it looks just like the kwikset lido lever. You will need an allen (hex) wrench to loosen the setscrew that holds the lever. Once loosened, it pulls off

kwikset allen wrench lever What is the correct size allen wrench for kwikset locks with lever/handle 2.5 mm 's

...remove has a latch with no screws, just two holes at top and bottom. I tried to use an allen inside those holes in the hopes to loosen the latch, but that didn't help. Would appreciate any advice. ...