Questions & Answers for: show change crank shaft sensor

...crank and it wouldn't turn over. Installed new fuel pump and crankshaft position sensor. I have no power going to my fuel pump, even after I replaced my fuel pump relay switch. WHAT COULD IT BE. look ...

...crank angle sensor or one of the other sensors cause this problem? yes the crank angle sensor can couse and but some time the coil test ant always right ether they may test good and be bad hope this ...

...up, have changed out, crank shaft sensor, mass air flow sensor, egr, and computer. And also ran fuel pressure check Any suggestions? do a compression test on all cylinders, check all 4 spark

...the plugs changed id do that, also check your coil packs.1443 canaster purge cyloined. another thing that will cause your problem and is common is the crank shaft sensor goes bad cost about ...

...the crank shaft posiction sensor, or the Cam shaft synchro do you have any codes? prior to this? the CSS Is know to come apart on fords, happened to me about a moth ago on my 99 taraus. hope this ...

1992 ford ranger with a 2.3 I replaced the ignition control module ; coil packs ; plugs and wires ; crank sensor .good fuel pressure cranks but no start no spark? Check the crank shaft position sensor

shaft position sensor that "comes to life" when rpms are up. or an injector has a bad spray nozzle allowing fuel to flow into its cylinder,pulling the spark plugs and checking for any that may be "wet

...crank shaft position sensor. still no spark from coil pack on #3 cylinder The coils are fired by the ECM, check all the wires to the ECM from the coils and make sure the signal is getting through and ...

...crank shaft position (CKP) sensor? The ignition system engine controller uses a distributor sensor with a sector wheel to provide the ignition timing. This distributor pick up coil provides the (CKP) ...

...show engine sign on dash, it cranks but not start Did you pull a coil an see if it has spark ? Does it have fuel pressure ? Is the secuity light lit or flashing when trying to start the vehicle ? Did ...