Questions & Answers for: set idle speed 1995 nissan

Question about 1995 Pickup

1 Answer

1995 nissan pickup truck starts and runs fine for first 10 minutes but when it warms up it wont idle and it loses all power. Change your O2 sensor and have your fuel pressure checked,the pump may be ...

Ad

Question about 1995 Pickup

1 Answer

...Nissan 3.0 pickup surges and stalls at idle. I often place in neutral and coast to stop to keep idle up. No warning lights illuminated, just surges and stalls. check error codes ...

Ad

...IDLE 1995 NISSAN PICKUP WHEN STOPPING GOES DEAD. IDLE JUST DROPS TO NOTHING. ALSO SEEMS THAT THE POWER SURGES OR IS UNEVEN, HOPE THAT MADE SOME SENSE. DanC Have you tried cleaning the throttle

1995 nissan pickup?? Unless you own a component tester then you really can not test it. You will need to see how the engine is preforming does it run smooth at an idle or does it hunt or idle too high

...idle gets really low like its going to die but it doesn't and here lately it runs really rough at any steady speed it feels like it hesitate the motor has 204,000 miles on it do a compression test on ...

...Wat could be the problem? I had the same problem on my 1997 Nissan Pickup XE. I got my mechanic to adjust the idle speed. It's a pretty simple and easy thing to do if you know what you are

...idle speed control valve and throttle valve. Buy a can of throttle valve cleaner from NAPA or Carquest or others (made by CRC chemicals) and spray it into the air intake while the ...

...idle speed, set parking brake & chock drive wheels, curb idle speed (750-850 RPM)transmission in neutral. IGNITION TIMING 2002 Nissan/Datsun Truck Frontier Pickup 2WD 3.3L SFI 6cyl The Ignition ...

...set the timing on a 1991 Nissan pickup truck 2.4 L 4cyclinder D 21 Autozone lists that engine timing at 10 degrees before top dead center with the engine warm and idling at 800 RPM. That is with the ...

...idle duty cycle to 50% as covered in the real service manual seem carb guys monkey this screw and IAC and PCM go nuts. if was messed with by others I set mine to 0.001" gap TV to bore inside the TB ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...