...close. getting it to close can be tricky. one trick i do is to remove it. and pack clay in the port sealing off all air to this port. start car with 10% throttle. then release the throttle , good ...
...out the vent tube to the tune of about one quart every 150 miles. I also replaced all the engine seals and gaskets. Front and rear main seals too which were also leaking. So now my oil leaks are a ...
...seal. What have I got to do to remove these drums on this particular vechicle Again this is an Isuzu Elf 150 N-Series, Thank You a brass hammer or punch really helps in this situation because you can ...
...Last thing I can think of, check well the smoke that comes out, when smoke is black is burning oil (seals get worn out and overnight oil might leak in places that later will get hot), if smoke is ...
...150 grams CV-joint grease. CV-joint boot Mounting bracket Oil seal and snapring Bearing and snapring Install the halfshaft and mounting bracket to the vehicle. Check the wheel alignment and adjust as ...
...T-Rex tape over that,plugged it in and put two shorter tie-wraps together to form one long one,and sealed the box back up.Now everything works!!! Best thing go to www.reliable-store.com they have
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions