...replace. I am having the same problem. Everthing that I have read sugests replacing the Thermocouple. If you've engulfed the last 3/4 to 1" of the tip of the thermocouple and it is glowing red and it ...
replace worn parts and ware to find them i have a garage heater and the megnetic switch chatters i have tryed cleaning it but i think it needs to be replaced.the model # 3E033 A, watts 7,500, phase 1,
...heater fans to cycle on and off quite often untill the air temp reaches about 55 degrees and then will operate normaly. If the fan still cycles too often you may have to replace the fan control and ...
...Heater, no spark It worked one day, then the next, no spark. Any Ideas where to start? Check to be sure the Ignition Device (transformer) is grounded, first, then see if power is going in to the ...
Question about Gas Furnace Heater
...heater use a fan to blow air through the heat exchanger? If the answer to those questions is yes, then check that the pilot orifice is not partially plugged and that there is a strong pilot blowing ...
...Heater - weak fire to ignitor I have replaced the ignitor (spark) plug and checked for worn wiring. I am getting a weak spark and the kerosene will not ignite. Could it be the wire going to the spark ...
...heater. Voltage to the unit is 123 Volts AC. So no voltage drop going on with the fan motor. Have you tried the flue vent? If not, an easy way to check this would be to take the vent pipe off of the ...
...coil on the valve and see if its getting really hot to touch. I would replace the valve you could have a fan problem or with a stopped up vent line the vac switch cuts the gas off if the there is not ...
...heater. I have replaced the thermocouple and the gas valve and burner will not ignite. The pilot lights and stays lit. The fan works as well. All what am I missing? A safety is holding out the main ...
Usually answered in minutes!
273 Questions
93 Questions
42 Questions
37 Questions
46 Questions