Questions & Answers for: Volvo replace control arm bushings

replace them with the new bushings. the cost of these bushings is nominal however have you checked the struts as well? the clonking noise could be them as well. please rate this......thanks if you can

...replace lower control arm on a 2001 volvol s80 non turbo pretty straight forward, you will need bar for refitting plus the 2 bolts are hard to access by engine I did mine without lifting engine but a ...

...replace those at the same time as the spring seat rubber cushions. Either of them failing can lead to a crunching noise. Not only that, but the lower control arms have bushings in them that wear out ...

control arms while replacing ball joints. The estimate is around $900. He advised me to watch for them. Any one has similar problems. He also mentioned he is not sure how long they have been there and

...control arms. The estimate is around $900. He advised me to watch for them. Any one has similar problems. Is it just bushings. You can replace just the bushings!, and the job should be MUCH less than ...

...don't want to buy something that is not necessary. yes you can but you may run into sizing problems. I recommend just buy thelower control arm. Cause if you need bushing. the arm is wearing. Replace ...

...but I still here the rattle. What could be causing the problem? have they checked the sway bar stabilizers,or if a lower control arm bushing has moved out of place.or maybe a strut bushing and ...

...replace control arm than the control arm bushings. Thanks 1989 ?? it a piece of cake ,nothing difficult ,about an hour to strip one side ,then go for spares ,stop for coffee and a piece of tortilla ...

...replace control arm or strut??? It comes as one whole piece and i just searched around for a control arm that might have removable ball joints, couldn't find one its one solid piece. Makes it cheaper ...

control arms. if there is any movement or sloppiness with them then they do need replaced. you will get a rotating movement at hte bolts and bushing as the tire is susposed to move up and down. but if