Questions & Answers for: replace blower motor resister 1998

Question about 1998 LeSabre

1 Answer

blower motor will not engage but heat still seeps out some times the blower comes on for a few seconds but will only work on high if at all. Need to know where the controller or resister is can't seem

Ad

Question about 2000 LeSabre

1 Answer

...BLOWER MOTOR blower quit blowing on higher speeds then quit all together. had a condensation drainage problem proir to this. have blower motor out. is there any to test it before buying a new one if ...

Ad

A/C - Heater blower will not blow at times . Smetimes it works, but seems to be a little irregular. replace the blower motor and blower resister at the same time /it will be a resister module

1998 BUICK LESABRE LIMITED WILL A MANUAL BLOWER 1998 BUICK LESABRE LIMITED WILL A MANUAL BLOWER MOTOR RESISTOR WORK ON AN AUTO SYSTEM no. the a/c control panel and wiring is different.

...heater motor still runs.kills the battery You need to replace the blower control module. Its near the blower motor, on the firewall. Follow the wires from the blower motor, it should lead you to

Question about 1998 LeSabre

1 Answer

...you need to replace the blower motor resister. on the inside, passenger side glovebox area or near the center. really easy to do. unplug the wires and take out a couple of screws, its that ...

...Air Conditioner blower motor run after turning the key off on my 1998 Buick Lesabre with manual A/C. Removed battery connection to stop. sounds like blower motor relay is hanging up replace ...

...blower motor was working and then only low speed now not at all. is there a resister in the electrical to the blower motor Yes. On most models high speed bypasses the resistor, so you could have a ...

Question about 1998 LeSabre

1 Answer

...blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is ...

...blower motor connector then jumper 12vdc to the spade sticking out of the motor it should run if not replace it. If the motor you get comes without a fan don't loose the spacer under the fan they are ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...