Questions & Answers for: Kia removing the motor cover

...motor mount on passenger side seems to be in the way of removing plastic timing belt cover. Does it just have to be finnessed out, or do I have to completely remove motor mount from engine? you must ...

...motor,Remove the black cover plate(6-8 screws).Next remove the contents within the "well"....The small boxes with the solid,yet wax-like-looking material within them.....and the plunger-ended spark ...

...1/2 hour, there may be a cover covering the motor also just remove that also if theres one. hope this helps.heres a picture of it i pointed out the three screw locations and just pull rubber hose

...motor mount (the one by the belts) using 17mm deep socket. It will give you better access to the bolts in the timing belt cover. 5- remove timing belt cover. (6 10mm bolts) 6- with the 21mm socket at ...

...cover plate. Remove 2 bolts at top of blower motor assembly. Remove 2 nuts that attach bottom of blower motor assembly to mounting studs on bulkhead. Remove blower motor assembly. To Install: Install ...

...COVER DISCONNECT THE WIPER MOTOR HARNESS CONNECTOR AND REMOVE THE WINDSHIELD WIPER MOTOR LINKAGE ASSEMBLY MOUNTING BOLTS.LIFT THE WINDSHIELD WIPER MOTOR ASSEMBLY FROM THE COWL AREA.YOU CAN USE SCREW ...

...Motor Mount next to the Power Steering Pump and timing belt cover -. Loosen the Alternator/Water Pump belt. -. Loosen the Power Steering/AC/Tensioner belt by loosening the Tensioner Bolt first. -. ...

...removing coolant tank but this only allows me to get my hand in behind motor and feel where the leak is, I cannot get any tools in the space. remove wiper arms 14mm remove rubber strip & plastic ...

why is the wiper fail to park and delay ? check fuses and the wiring at the switch and motor I'd say your motor is starting to fail. But a Chiltons/Haynes repair manual that covers your car has ...

...motor (new) on line for about $40 but not sure the steps to replace it... including removal of door panel. Remove the door handle and arm rest screws then get a flat blade and prize the cover off ...