Questions & Answers for: Brother HL remove rear door cards

the printer. Open the rear door and check there first. If that's not it, remove the toner/drum assembly and check behind that. The other place to check is between the drum unit and the toner cartridge

...rear door and then the inner rear door. Unfortunately it requires replacing the full fuser and it's expensive. Approx. $170.00. I know the news is not good but hope it helps you. Call Brother if it's ...

...rear door or front and removing toner, or cassette, if it is crumpled in fuser, then it aint easy without pulling it apart, sometimes a manual feed via hand of a pice of stiff card or laminate in ...

...maximum paper path can be check once you remove toner cartridge and if you don?t find any paper in this area check rear door and you may find paper below cover area , paper can be access and ...

rear paper jam Paper jams can be tricky to solve. The paper is usually stuck inside the printer mechanism so even if there is no visible paper jam, you will still get the paper jam error. Try this: 1.

...rear paper jam? I can't find anything wrong with it. Where should I look specifically? Open the back door and look in the middle of the back cover, there's a black plastic sensor lever that must move ...

...remove and check. 11.Go back to inside the printer body, using a flashlight, check the rear right side(the other side of the red heating drum). You can see a block sensor unit. If you see Cyan toner ...

remove disassemble and reassemble the printer and now it's back to working as before. Sticky door here too, it's easy to test from the front after taking out all the internal parts that slide out.

and you will see haw this thing works, if it does not move freely, it will trigger rear door open, be carefull with this piece of plastic, it does break. again it will trigger an open rear door error

...rear door. then remove the paper cassette and ply the cover off both at the front and rear, downward to remove.once the cover is off, look at the front end and you should see a larger black gear with ...