Questions & Answers for: remove distributor manifold

remove distributor. Remove upper radiator hose at thermostat housing. Disconnect accelerator and cruise control cables. Remove heater hoses from intake manifold. Remove EGR pipe. Disconnect fuel lines

...distributor cap hold down screws and remove cap NOTE The rotor is friction-fitted to the distributor shaft and can be pulled straight off. Transfer cables from old cap to new cap. The cap and cables ...

...distributor and oil releasing unit and on the V-8 these are located under intake manifold. You?ll need to remove the manifold (intake) to get to sensors. Please do rate the solution and revert for ...

...Remove distributor to spark plug wires (12286) using Spark Plug Wire Remover T74P-6666-A. Disconnect muffler inlet pipe. If equipped with secondary air injection, disconnect the secondary air ...

...distributor cap Remove the ignition coil arc seal. Clean the cap with a soft cloth and inspect for defects. Replace if necessary. To install: Place a new seal on the distributor cap. Position the ...

...Remove the distributor and label the spark plug wires. STEP 2 Remove heater hoses and bypass hose. STEP 3 Remove upper radiator hose. STEP 4 Remove EGR valve? STEP 5 Remove sensors and bracket on ...

...remove distributor from engine.INSTALLATION Install rotor on shaft. Position distributor in engine and ensure O-ring is properly seated on distributor. Replace O-ring if it is cracked or nicked. ...

do you have to remove distributor to change head gasket on a 1998 350 ? Distributor and intake manifold as well as anything else in your way needs to be removed.

...distributor 5.7L V-8 Remove the dist cap and then mark the direction that the rotor points, next unplug the connectors to the distributor, take care not to break the connector locks. Next remove the ...

...manifold from a 1974 cadillac eldorado Pull the distributor & remove the intake manifold bolts Doesn't sound as though vehicle repairs are your area of expertise,best forget it or pay ...