Questions & Answers for: kawasaki reed

what is the part called that goes between carb and reed on a kx 8 part name for a kx80 - part between carb and reed Intake manifold or intake manifold gasket depending on which part you refer to.

kx 125 reed valves I need to know how you know if the reed valve is bad on kx 125 looks to be not broken or chipped or bent open in any way... The reed valve assembly should hold solvent withot ...

kdx 200 running lean or rich no not know. you know how a 2 stroke will clear up and really go when you are in the power band, well mine will not stay cleared up in its power band, I have cleaned the ...

...bike wont start and bikefires .when kickstart or bumped ... any help pls Sounds like sand in the reed valve block. Take the carb off & carefully remove the reed block ensuring no more sand

...80 HAS 65 PSI COMPRESSION AFTER TOP END REBUILD VERY HARD STARTING You may have a problem with your reeds.If you have done a rebuild because something internally has destroyed itself then the chances ...

is a power valve spacer and i reed block spacer the same thing? reed valves are in the intake rubber manifold, so the fuel mix can only go one way into the motor, Power valves are on the exhaust side ...

...on the top end. I replaced the exaust pipe orings so there is no exaust leakage. I took off the reed cages to see if there was a broken reed, but there wasn't. The one reed cage looked normal, ...

...all the obvious things like lines and everything seems ok.is my piston burnt out?need new jets?new reeds or valves?previous owner removed packing from exhaust so it's hollowed out idk if that

How do you replace the reeds on KX 250? Remove the carburator to gain access. Unbolt the reed block from the back (rear) of the cylinder. You can replce the reed block assembly, or if you just got the

ok I have a 03 model kx 250 it has new top end crank and boyesen carbon fiber reeds its having problems cranking and its bogging like the power bands aren't working I have adjusted the carb and ...