Questions & Answers for: Chevrolet Malibu how to put together

...kno what exactly you are putting in if it is the adjuster you will have to adjust it all the way in before you can put it back together or find a way to put it on there while you put everything back ...

water outlet assembly can put it together but every time end up with a leak in another spot , replaced the assembly twice You talking about thermostat housing?

...i just replaced the intake manifold gasket cleaned out the lifters and put it back together now i can't get the car started it keeps back firing and dont start Bad timing - rearrange the

...This causes the valve timing to be quite off once everything is put back together. Checking to make sure that compression is proper in the engine should resolve whether or not this is your

...but it still does the same stuff. what can i do? Here is what you can try disconnect the battery put terminal together, reconnect put key in ACC position for 30 sec (approx)then see if it

...and the pushrods and put everthing back together and the motor is still tacking usually the valve springs needs replacing when replacing the lifters Do a compression check to find the weak ...

together. there is 2 different lengths of rods which order do they belong? One rod will be for the inlet valve and the other for the exhaust valve turn the engine over till you get TDC and install the

...gear on as well and tensioner. These must all come off together. Also must be kept together while putting them back ...

...put back together will fire no fuel pressure wont start checked fuses and relays Check to see if fuel pump is working should be able to hear the pump when you turn key to start position if so check ...

...PULLED THE CENTER OUT OF IT CAN I PUT IT BACK TOGETHER 1999 3.1 MALIBU IF SO HOW IS THE EASIEST WAY TO GET IT BACK IN THERE No, you'll have to replace it. They are pressed on and can't be