...for 1 min before you rev it up. Enjoy your riding. if this still happens after she"s warm i"d say your clutch needs topping up with clutch fluid and bleeding. good luck What kind of fluid do you ...
...it rough you can smooth it out with a file to but be cautious of how much you file down. I'm assuming you have checked/replaced the fluid in the hydraulic clutch, and checked for any bubbles. Good ...
...fill slowly....tighten bleeder and work clutch to check for pressure and unsure there's no air. BE SURE TO NOTE IF IT USES DOT4 BRAKE FLUID OR MINERAL OIL MAGURA=MINERAL OIL BREMBO=DOT4 SOME RACERS ...
...proper way to install the fluid is to fill it with a syringe from the bleeder screw until the reservior is full. This insures there is no air in the system. There are kits available aftermarket ...
...fluid. Fill the system by injecting it through the bleeder screw SLOWLY. Always close the bleeder screw before removing the syringe or you'll get air in the system. Continue to fill until the ...
...clutch hand dosnt feel like its working at all it feels loose You will need to slightly loosen the line where it goes into the master cylinder,...then squeeze the lever and hold it in...fluid should ...
...the clutch is not pulled in sounds like you have bad brake fluid ...you need to flush the master cylinder completely ...with new clutch fluid ..if that does not cure it ..then new clutch spring
fluid for clutch pump or oil for the engine? If you ask about oil for engine KTM recomend Motorex Power Synt 4T 10W-50. If you ask about the clutch brake fluid you will need brake fluid DOT 4 or DOT 5
what to use for clutch fluid for 2008 ktm 450 sxf clutch fluid Magura blood do not use dot 3 or 4.
...clutch add hydraulic fluid to the master cylinder. Look on top of the master cylinder cover for the correct fluid. You might need to bleed the system to get rid of any air if the fluid went too low. ...
Usually answered in minutes!
52 Questions
45 Questions
33 Questions
29 Questions
25 Questions