...pressure sensor switch solved this problem 3 yrs ago, but not this time. I even replaced the circuit board ($300!) to no avail. HELP! oil temp also? and or pressure. fuel shut off valve? switch bad ...
...pressure switch could bring the light on... so check this before you have the engine stripped!!!!! An oil change will cost very little money and could solve the problem, if the light is still on with ...
pressure switch located on the right front of the engine block, and then if it has the 2.5 engine then the oil pressure switch is located on the leftside of the engine block above the oil filter, good
...one from dealer problem gone. ALSO . you may want to hook up an mechanical oil press gauge to pressure switch port to see what the pressure actually is to be sure you do not have low oil
...pressure switch on the lines or the compressor. The low switch cuts power to the compressor if freon or pressure is low, high cuts power if pressure in the system goes over 300 psi. It ...
...pressure switch, or the relay, or put power directly to the ac clutch ?You have a low pressure switch that should be closed and a high pressure switch that should be closed to put power to the ...
Question about 2007 300
...pressure switch on my 2007 Chrysler 300 but the light keeps chiming? I only have about 68,000 miles The you really do have low oil pressure? have this checked asap with a manual test gauge. Do not ...
Question about 2003 ES 300
...pressure switch. As an aside, I worked in a place with artwork from a very accomplished Toronto artist who signed his artwork just 'HOXHA'. ...
2005 chrysler 300 hemi obd code po 521 Oil pressure replace oil pressure switch if it doesn't help have the engine checked out
raybak pool heater says flo and will not run dirty filter or pressure switch or loose wires to pressure switch or plugged inlet to pressure switch
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions