Questions & Answers for: Chevrolet Silverado 1500 pinion seal

pinion seal in need of replacing but also have a howl leading me to believe i need new bearings also. But ontop of that it also does a low rattle/vibration when i take my foot off the gas while on the

pinion ? well if the axle is leaking you dont need to adjust the shims, it needs a new seal. pull the brakes off open the rear diff there will be a c lip holding the axle in, remove the c lip pull the

...the pinion seal.Which is a fairly easy job.If you are replacing the pinion shaft itself then the axles and the complete rear carrier has to come out.Then it has to be set up.Hope this helps.Good

...pinion, took yoke off did'nt mark nut or count threads. Manual says that you should do this for reasembling. How tight should I tighten it? If your just replacing seal and bearing just tighten back ...

how to change front seal of rear differential on 2006 chevy silverado remove the driveshaft remove the pinion nut and washers remove the seal

pinion seal and it is new do i have to put silicone around the splines to seal it If the pinion is not tight enough,and the pinion moves up,and down and side ways then you need to set the pion up with

...Pinion seal replace and universals. After 400 miles has bearing sound in rear. Took it in and it was found that pinion nut was too tight. Shop replaced pinion bearings, spider gear,seals. After ...

... HI, If you have a gmc axel pinion seal nut torque is 270 FT.LBS or 366 NM If you have a dana axel pinion seal nut torque is 255 FT.LBS or 346 NM If i can help you anymore just re post Thanks dodge ...

...pad "nails" or stuck self adjusters or even rust on the drum edge). . Third would be the ring and pinion followed (requires draining and pulling cover). Hope this ...

pinion seal will have to be replaced. with the drive shaft removed you can remove the nut holding the yoke to the pinion gear (rear end) ,pop out the old seal and drive in the new seal, then reinstall