Questions & Answers for: peugeot 406 door lock

peugeot 406 central locking I had a service on my 406 hdi estate and the garage disconnected the battery. Remote central locking doesn't work now. Key will still do central locking from the door you ...

Peugeot 406 estate, locking problem The locks are not working on my Peugeot 406. Remote stopped working a couple of weeks ago after being intermittent. I could lock/unlock with the key - but now the ...

Peugeot 406. Remote locks all doors. On unlocking passenger and rear doors unlock,drivers does not. I press the remote again and the mechanism sounds like it locks and unlocks, and I can then get into

406 door won't open. The offside rear door on my 2003 406 estate will not open, i have taken the trim panel off to see inside and both the rods for the lock and door handle are working, but the door ...

...peugeot 406 key fob my central locking locks then unlocks i think the key fob may need resetting. thanks Paula Had same trouble with my 406, fixing no problem, with new battery in fob, insert into ...

...peugeot 406 hdi pass door lock wont lock so car wont lock does this every few weeks and stops very anoying Remove the door pannel and spray releasing oil over the central locking solinoid.That should ...

peugeot 406 door lock barrel just spins and wont unlock? hi.just try to oil the lock an try to take the key in and out and turning some times. on peugeot this is a normal problem. need to replace the ...

406 Peugeot the remote didnt work so i opened the car on the driver side but the lock just kept spinning , now the remote wont work and i cant lock or unlock the passenger side door or the driver side

...Peugeot 406 exec 2.2 hdi (2002) This started approximately three weeks ago after the really cold spell and the snow. We only knew there might be a problem because when parked up the hazard lights ...

peugeot 406 central locken locks then unlocks Hi. usually caused by faulty drivers door lock motor. It controls the rest so if it fails then it will stop the rest operating properly. check the wiring ...