Questions & Answers for: Honda pedal

with the K20A engine and 6sp transmission? correct? yes the clutch is adjustable. loosen the clutch pedal position switch(lower of the 2 switches) locknut and back off the clutch pedal position switch

...the clutch has ever been replaced but the clutch works fine but only for the last tenth of the full pedal... a better explanation i guess would be that i have to basically almost let my foot off the ...

...you The owner's manual offers these tips on starting in cold weather. First, do not touch the gas pedal and crank the engine for no longer than 15 seconds. If no start, hold the gas pedal halfway ...

clutch pedal wont spring back, If the clutch is good and works right, then probably the big spring on the clutch pedal under dash may have come loose or broke. You need to look at the pedal operation ...

clutch pedal straight to floor felt a pop and clutch pedal went straight to floor and car stalled and wouldnt even turn over for restart If you put the trans in neutral and depress the clutch pedal it

yo I have a 1990 honda prelude si ,I have an issue with clutch pedal, my clutch pedal seems to stick when depressed it still has good pump pressure but I have to lift it up. Now I live in Idaho and it

accelerator pedal position sensors I have a 2006 honda accord LX 2.4. Engine light came on with code P2135 throttle pedal position sensor. Replace the pedal sensor and the throttle body and still have

clicking noise brake pedal When I apply my brake then release it , I will hear a click sound usually once or twice only when releasing the brakes . It sound like its near or around the pedal area. ...

how do u adjust clutch pedal You adjust the pedal height by turning the clutch master cylinder pushrod which is attached to the clutch pedal under the dash. Loosen the locknut and turn the rod to ...

how do you reset the gas pedal If you are "resetting" the gas pedal because you replaced it..... you will need to return to the Honda dealer to have your computer "flashed" . The pedal MUST be ...