...- Damaged ignition coil - Damaged PCM or Possible solution - If damage, repair ignition coil circuit - Replaced ignition coil - Replaced PCM or ECM Hope helps with this (remember to rate this
...ignition coil - Damaged PCM or Possible solution - If damage, repair ignition coil circuit - Replaced ignition coil - Replaced PCM or ECM When is the code detected? The test fails when the Powertrain ...
...PCM) controls each ignition coil operation. The PCM sends a ON/OFF signal to energize the ignition coil to create a spark at the spark plug when a spark is required at the cylinder.Possible Causes - ...
Question about 2006 Cobalt
...PCM, question: is the ignition control unit inside the ECU-ECM-PCM? no power to the cranksahft and camsahft position sensor and no start. and i think is the ignition control module or the pcm. It ...
...The IC circuits transmit timing pulses from the PCM to the ignition control module to trigger the ignition coil and fire the spark plug. The PCM controls ignition system sequencing and timing ...
Question about 2001 DeVille
...pcm dtr and relays all ok transponder in keys ok ignition relay ok think ignition switch problem ? bench tested starter new bat no burned wires Awd merc 02 ????? Mercury what ? Transmission range ...
Question about 2001 DeVille
ignition diagnostics. The PCM continuously monitors the ignition system for concerns. The P2308 code sets when the PCM detects a short to voltage in the circuit. Videos on youtube for testing Computer
Question about 2001 DeVille
...PCM) supplies a signal on each of the ignition control (IC) timing control circuits to the ignition control module (ICM). The ICM fires the correct ignition coil at the correct time based on the ...
Question about 2001 DeVille
...Ignition Key Transponder PCM GO to Pinpoint Test C . B1602 PATS Received Invalid Format of Key-Code From Ignition Key Transponder PCM GO to Pinpoint Test D . B1681 PATS Transceiver Module Signal is ...
Question about 2006 Navigator
...Ignition Key Transponder PCM Go To Pinpoint Test C . B1602 PATS Received Invalid Format of Key-Code From Ignition Key Transponder PCM Go To Pinpoint Test D . B1681 PATS Transceiver Module Signal is ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions