Questions & Answers for: Casio paper feed does not feed paper

...feed it through the back, then cut the paper to form a V then feed this from the bottom and finally when you push feed it grabs the paper! Why they never put this in the instructions is beyond

THE RECEIPT PRINTER DOESN'T FEED THE PAPER IF YOU PULL THE PAPER IT PRINTS BUT WILL NOT FEED THE PAPER ALTHOUGH THE LOWER GEAR MOVES THE UPPER GEAR ISN'T. Hi. Can you tell me the model number?

...feed, the paper is not under the wheel far enough. This should work on other similar models as well. When feeding the paper through it helps if you first pull it across the edge of a counter or back ...

...feed in paper in My HR 8TE calculator Hi, Here are the steps for feeding the paper into Casio HR8TE calculator First feed it through the back, then cut the paper to form a V, then feed this from the ...

...wheel. The repedably hit the feed button until the paper comes out the other side. If it does not feed, the paper is not under the wheel far enough. This should work on other similar models as

...posible residual and then cut 3 1/2” of electric tape and split about the wide of the roller and roll on the roller in the same way that it move to feed the paper.Casio NR-8TE AND IS WORKING FINE

...paper feed out of the left side at all? If it feeds, but is blank, turn the paper around so that the shiny side is facing toward the front of the machine as it exits the printer. If it does not feed, ...

...feed paper in and it seems to be jammed keep getting an E on screen cut the paper evenly with scissors before attempting to feed it into the paper entry port. If you just rip it, it will jam or fail ...

paper in and pressing feed makes the wheel spin but does not pull the paper in. should be a release arm on it Try clean the tiny black roller in the back of the black plastic (see picture). It doesn't

paper? feed bar spins but will not catch I have a casion hr-100tm calculator and found the easy way to load a new roll of paper. Take a 3x5 index card and cut it on 45 degree angle, then with angle on