Questions & Answers for: olds cutlass ciera ignition module

Question about 1991 Cutlass Ciera

2 Answers

...cutlass ciera i was driving my car going on to the express way as my car stalled i pulled off the side of the road and tried to start it back up it would not start it would turn over tho. one guy ...

Ad

Question about 1992 Cutlass Ciera

1 Answer

...olds cutlass ciera keeps stalling out is there a main relay switch or ignition module switch that can be replaced? Where is it?Anyother ideas what could cause it to start, drive a few blocks, then ...

Ad

Cutlass Ciero 3.1 engine starts and dies won't stay running Replace the oil pressure switch next to the oil filter. When you turn on the ignition the fuel pump runs to prime the system then turns off.

...olds cutlass ciera 2.8 liter i have the same problem mine won't start when its warm if i spray starter fluid in it it will start sometimes but others it won't i have replaced the idle air control ...

...Cutlass Ciera with the 2.5 will not stay running My Oldsmobile Cutlass Ciera with the 2.5 will start, idle for a second and shut off. I've replaced the whole fuel pump assembly, fuel filter, MAP ...

Question about 1988 Cutlass Ciera

2 Answers

...Ciera 3.8 v-6. It will run for 10 minutes and than shut off. I have replaced the ECM and the ignition module and the coils have been checked and they were fine. Any help would be greatly appreciated. ...

...olds cutlass cierra s with 3300 v6, dies when warm, rest for about 15 min and starts up till warm. replaced ignition module, o2 sensor, fuel filter, fuel pump, air filter. i've worn out my auto ...

...Olds Cutlass Ciera (2.5L)with engine problems that I cant figure out. Originally the car would start and run for a second or two and shut down. It would die because the injector would stop spraying. ...

Cutlass Ciera seatbelt, key in ignition, lights left on warning alarms and auto locks not working; plus, ABS warning light stays on and dome light is not coming on, is there a central The details are:

...crank shaft sensor and the coil packs still nothing its a 88 olds cutlass ciera 4tech 2.5 If there no spark and the connection of the ICM is making good contact this lead you to the PCM as the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...