Questions & Answers for: Buick Century ohm spec ignition wires

Cruise will not light up or work on 95 Riviera I have checked all fuses but no luck. Just quit working? Any ideas appreciated. Check the switch to make sure that it works first. Remove the wire ...

...spec for the coils are 5000 to7000 ohms, measured between each coil from tower to tower (ie) #1and#4 2+5 and 3+6 any more than that and the coils are toasted..lol hope this helps also check the spark ...

...(one wire) should trigger the fan in most cases. Jump wire power to the fan to test if volt/ohm meter is not

...ohm out the same or is open. The harnesses that go to the front wheel speed sensors are also pretty common to either corrode or have broken wires. Unclip the harnesses from the lower control arms and ...

wires and tell if they are good, this can only be done with an ohm meter. The resistance should be 3000 to 6000 ohms per foot of wire. One other note is if your car feels sluggish or lacks power is to

...raidio shack that is same amount If you still have the key ,just measure the resistance of the chip in the key ,then wire the same ohm resistor into the 2 white wires that go into the ign.

...ignition module, fuel regulator, plugs and wires, fuel filter. When changed the fuel regulator it started and ran great, shut it off and now will not start again, shoot starting fluid into the air ...

...ohm meter while relay was clicked and got connection. im not getting power from pcm to power relay. dont know if something is wrong in ignition circuit or anything like that. or if pcm is bad. need ...

...ignition lock cylinder > Coming out of the back of the lock cylinder are two wires that travel down the steering column ! These wires break inside the cylinder ,causing the resistor pellets value ...

1992 buick century 3.3 what should the fuel injector ohms be reading or the voltage should be reading. i checked mine 4 of them are reading in the 20s voltage what should the ohms be reading or the ...