Questions & Answers for: Chevrolet off line

...the fuel line off. It is a plastic ring that is split in middle and it fits over the fuel line and you push it in to the fitting and then pull them apart. They should hook you up with what you

Ad

...compartment. To the right is a big black drum with a thing extending out with steel lines coming off. This is the master cylinder and the lines coming out are the brake lines. They branch off to ...

Ad

after having someone change the valve cover gaskets my truck won't stay cranked when taking foot off gas. check vaccum lines Look closely. Is there any vacuum lines off? Unplugged sensors? and or ...

Question about 1997 Suburban

1 Answer

line adapter. This is also a simple fix but you're going to need a drumlin tool cut off the old compression clamp that was press fit. Cut off the old compression fitting ring, use cation that you only

Question about 1997 Suburban

2 Answers

...line off gas tank on 1998 gmc seria this has to be done with a special tool but is not expensive at all i'll say under 10$ you push the fuel line disconnecting tool in the gap between the connexion ...

Question about 1998 Cavalier

1 Answer

...off the line until i can get it fixed?. the brake pressure in the lines when applying the brakes will leak if you try to block the line off.you can tell what line it is by having someone press on the ...

Question about 1988 S-10

1 Answer

...line off and checking for fuel laying inside line.If fuel is in line replace regulator.If no fuel in line then check pressure it should be 9-13 psi with key on engine off.If not within specs replace ...

Question about 1998 Malibu

1 Answer

...lines coming off the compressor, a large line and a smaller line. The larger line is the low side line. Follow it and you will find the service valve. It will either in the line or on the

off. First - find which tire the brake line goes to that you just fixed. Two - then have someone in the vehicle pumping the brake three times, then on the third time, have them hold the brake to floor

...off the master cylinder you won't find it you have to make it yourself. You have to buy a line from any parts store and cut and bend it to your needs. I always reuse the end connectors if they're in ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...