Questions & Answers for: nissan d21 rough idle

...nissan d21 idles rough and u have to shift befor 2200 because it acts like it is taking out. and doesn't really have alot of power put new plugs wires throttle body sensor map sensor coil packs.... ...

...D21 ka2.4 I jared the truck while off roading and truck started running rough with bad miss fire thru out rpm range, surging at idle, very low idle, and running very rich. Idles normal with mass air ...

...Nissan D21 4x4 VG30 V6 manual trans) began running very rich little by little. If the truck is cold or has not been driven for a long time it runs great. Once I stop the truck for a little while and ...

...Nissan D21 pick up V6 4WD Manual Trans I graciously thank you in advance:) The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission ...

...nissan d21 truck 4 cyl 4wd. 203k miles on it. while driving it suddenly started misfiring. now it runs rough, will kill without pushing the gas pedal (if you push down on the pedal too much and too ...

...Nissan D21 with a Z24 motor: Continuous stalling at idle, runs when choked using a rag or hand, has new plugs, wires, distributor cap, rotor button, fuel pump, will not idle unless choked, i do n I ...

nissan D21 automatic wont move when running I have a 1993 Nissan D21 Hardbody Pickup. It's an automatic with 104K miles. The previous owner had the engine rebuilt roughly 30K miles ago. It has been ...

Nissan d21 pickup? The engine idles rough and dies. It also surges at freeway speeds. when engine is idling I reach under air filter and gently touch harness that's plugged into MAF and it changes rpm

...nissan d21 z24 4wd The engine idles roughly. ... You have trouble starting your car in the morning. ... Your car's engine misfires. ... Engine surge or hesitation. ... High fuel consumption. ... Lack ...

...nissan D21 pickup truck? the engine is running rough and black smoke is coming out the tail pipe i replace new spark plugs, wires, coils, fuel filter, but when i disconnect the mass air flow sensor ...