Questions & Answers for: Chevrolet Silverado motor cover

Question about 2004 Silverado

1 Answer

...motor insulating cover screws. Disconnect the electrical connector from the blower motor. Remove the blower motor insulating cover. Pull the retaining tab down while turning the blower motor ...

Ad

Question about 2004 Silverado

3 Answers

...cover. 2. Locate the motor resistor to the right. Using a 5.5mm ratchet, remove the 2 screws holding the unit in place. Remove the 7 pin connector from the old unit. Follow the 2 strand wire up and ...

Ad

Question about 2006 Silverado

1 Answer

...cover, molded to fit the blower motor and hide it from view. This cover is also insulated to reduce the fan noise. Removeing this cover is the hardest part of the job. After removing the cover, there ...

...motor resistor maybe bad. There id a plug in deal right under the passenger foot cover and if the kick it that goes bad so what I did I went to the wrecking yard and got a new one because the dealer ...

...motor insulating cover screws. Remove the blower motor insulating cover. Pull the retaining tab down and rotate blower motor counterclockwise to remove. To Install: Position the blower motor and turn ...

...not turn off. I have unplug wires from the motor to shut it off. Do I replace motor and is it difficult. On the wiper motor is the speed control circuit board under the wiper motor cover, replace

where is the wiper pulse board on my 1989 c2500 cheverolet silverado remove the 4 torx bolts on the back of the wiper motor and pull cover off and the board is the cover

...motor insulating cover screws. Disconnect the electrical connector from the blower motor. Remove the blower motor insulating cover. Pull the retaining tab down while turning the blower motor ...

...window wiring diagram driver's power window does not go up or down. some monkey replaced the window motor and switch I'd check the wiring harness on hinge side of driver door. Probably has a ...

...motor cover a few times with the handle of a screwdriver. If the wipers begin working after a few taps the cover is most likely faulty. The best part is that if that is the culprit it is fairly easy ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...