20 Most Recent
2004 Chevrolet Silverado Questions & Answers
2004 Chevy Silverado. The Service Airbag light is on, but no error codes?
Question edited for clarity.
Question moved to model category.
Resetting the airbag light on your Chevy Silverado should be easy to do. Follow this video to watch it being done in a Chevy Silverado. To start with, you will:
- Put the key into the ignition
- Turn the key to the "on" position
- Wait for the airbag light to turn on
- Wait to continue until the airbag light turns off (around seven seconds)
- Repeat the same steps twice more
- Turn on your engine
After you take these steps, your airbag light should turn off. If it doesn't do so, then you should consider taking your vehicle in for diagnostic testing.
If the airbag light remains on, it could mean that something in the system is faulty. That could mean the airbag, the computer wiring, or another issue. Oftentimes, when the airbag light comes on unexpectedly, it is because of interference with the switch.
Feb 12, 2021
How Do I Reset the Airbag Light on the Chevy Silverado?
Vehicle History
https://www.vehiclehistory.com > articles > how-do-i-res...
..
2004 Chevy Silverado. Reduce engine power
Question edited for clarity.
Question moved to model category.
Yes, aftermarket alarms can cause problems like that, and remote starters are even worse. Better to stick with what the factory designed and put in.
The check engine light has a code and that will tell you what the issue is. You need someone with a scan tool.
2004 Chevrolet Silverado transmission
4L60E transmission should have come in your truck and if you are putting the same one just those few years difference it should fit they have to both be the 4L60E trans, Good Luck
Gap for 2004 silverado 4.8
Make: CHEVROLET
Model: SILVERADO 1500
Year: 2004
Engine: V8 - 4.8L - FI - - GAS
GAP = .040"
I suggets PLATINUM sparkplug (Morotcraft, Bosch, Champion)
Hope helps (remember to rate and comment this).
I have a high pitched
Okay what you want to do today I can host this is to take all of the accessory belts off of the engine start the motor and listen for the sound if you don't hear the sound then you know it's your alternator or one of the other accessories the reason you take off all of the belts is to see if it's a timing belt what you would not be able to take off cuz that's inside the motor the only way to diagnose it is to do this.
My 2004 chevy truck 1500
high pressure or low pressure switch is bad,unplug them and jump them to see which one is bad,on a GM,I have found it was always low pressure switch on the dryer that was bad,hope this helps
Not finding what you are looking for?