Questions & Answers for: minimum thickness wheel rotors

Question about 2004 Sequoia

1 Answer

...Replace the front rotors. Refacing does not work on Sequoias. The metal removed to get the rotor "true" is usually below minimum safe thickness, and the vibration comes right back when it gets

Ad

...minimum thickness standards for safety) or you can replace the warped rotors with new ones. In both cases, I would recommend also replacing the brake pads too. Hope this helps. brakes yes rotors ...

Ad

...minimum thickness rotor thickness is stamped on the brake rotor. To install: Place the brake rotor to the hub. Make sure the mating surfaces are free of rust which may prevent the brake rotor from ...

...minimum thickness that it can be lathed to. (Cut to) Brake rotors resemble a flat disc, and there is a minimum thickness that they can safely be cut, (Lathed), down to. Brake Drums resemble a round ...

minimum thickness shown on the rotor, it should be replaced. The finished braking surfaces of the rotor must be parallel within 0.007 in. (0.178mm) and lateral run-out must not be more than 0.003 in.

...minimum thickness have rotors machined or buy new ones reassemble do not damage caliper piston boot do not disconnect brake line loosely install brake reservoir cap have proper brake fluid handy if ...

Question about 2010 Outback

1 Answer

...minimum thickness I don't know the min thickness, but I have an outback just like yours and if there is a problem with uneven rotors it's usually cheaper and easier to buy aftermarket at NAPA auto or ...

minimum thickness for buick lesabre front rotors minimum thickness of front rotors Hello there From a kind chap on this page http://buickforums.com/forums/threads/18395-Service-limits-for-brake-rotors

...minimum thickness, warping is more likely. If you replace the rotors, replace the pads at the same time. The pads that are on the car now are wearing unevenly due to the warped rotors and can cause ...

...and not warp(pedal or steering wheel shakes when braking), Reuse them. Using this theory you can get up to 3 sets of pads off the rotors. The minimum thickness is stamped on the edge of the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...