Questions & Answers for: Chevrolet Tahoe low signal

Question about 1996 Tahoe

1 Answer

...low the signal voltage is low. When pressure is too high the PCM will not allow the A/C compressor clutch to engage. Action Taken When the DTC Sets The malfunction indicator lamp (MIL) will not ...

Ad

Question about 1996 Tahoe

1 Answer

signal circuit goes low and the liftgate module determines the switch to be active. DTC B153A 00: Liftgate Latch Switch Signal Circuit DTC B153A 08: Liftgate Latch Switch Signal Circuit Signal Invalid

Ad

...own seperate battery and transmitter to send a signal to the BCM ( Body Control Module ) Either you have Low Tire Pressure at a certain tire or you have a low TPMS battery or a bad TPMS

I have a 2002 Tahoe LS and my low and high beams do not work, but my fog lights and daytime driving lights work, as well as the dash lights. Any ideas? the high beam indicator does not come on either.

...low. You need to check to see if the transfer case shift motor is getting signal. Easiest way is with a decent scan tool. If the lights light up on the switch then the system is powered if not check ...

Question about 2007 Tahoe

1 Answer

...signal ranges, from 0.13 to 3.30 volts depending on vacuum levels. The low reference is the return side of the sensor to ground. Conditions for Setting the DTC ?€¢ Voltage at the brake booster sensor ...

...Low Level Audio Signal (+) (UQA/UQS) 6 D-BU 46 Right Rear Speaker Output (+) (UQ3) D-BU 546 Right Rear Low Level Audio Signal (+) (UQA/UQS) 7 D-BU 658 Cellular Telephone Voice Signal (UE1) 8 OG 6978 ...

...Low Level Audio Signal (+) (UQA/UQS) 3 L-GN 200 Right Front Speaker Output (+) (UQ3) L-GN/WH 512 Right Front Low Level Audio Signal (+) (UQA/UQS) 4 PK 5149 Voice Recognition Audio Signal (UE1 ...

...signal circuit goes low and the liftgate module determines the switch to be active. The handle switch and close switch are parallel circuits and provide a single input to the liftgate control module. ...

...low, the signal value is near 0 volts. When the A/C refrigerant pressure is high, the signal value is near 5 volts. The PCM converts the voltage signal to a pressure value. The A/C refrigerant ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...