Questions & Answers for: location coolant temp sensor 2000

Question about 2000 Crown Victoria

1 Answer

said problem with coolant temp. sensor. where is it located on the 4.6 L engine? hello lipounds , the temp sensor located on the passenger side front of engine near the #1 injector . hope that fix ya

Ad

Question about 2005 Crown Victoria

1 Answer

...starts to flood out and wont start back till next day ...then same thing....help!!!! if it starts to flood it may be the coolant temp sender. it could also be the crank angle sensor. hope this

Ad

Question about 2000 Crown Victoria

2 Answers

For

...coolant temp sensor checked for proper operational voltage ranges. and also check the coolant level to be safe to see if its low. It may be low giving you false readings at the sensor. Leave feedback ...

...coolant temp sensor for the computer? YOUR ENGINE IS GETTING TOO HOT.THERMOSTAT BAD OR RADIATOR CORE CLOGGED AND FRONT GRILLE AIR FLOW BLOCK FROM DEBRIS OR THE COOLING FAN RELAY STUCK CLOSED POSITION ...

...resistor is most likely bad. It guages the temperature of the coolant and controls voltage levels to the fan. It acts as a switch, similar to a coolant temp sensor does in the engine. Good luck!

where is the ambient air temp sensor for the 03 crown vic p71 i have a 99 crown vic suvillan and i cant find the ambient air temp sensor where is it please help

...temp 100 degrees). Starter cranked just fine, but wouldn't turn over. 30 minutes later started right up and took me home (approx. 1 mile). 8 o'clock that night, drove 6 miles - no problems. ...

Question about 1995 Crown Victoria

2 Answers

...coolant temp sender could be bad. locate the temp sender. this is a 1 wire sensor. the other sensor in the block has 2 wires and starts the cooling fan. Hi eve valve is not related to u r temperature ...

Question about 2000 Crown Victoria

1 Answer

location of coolant temp sensor 2000 crown vic low cooling fan stop working If the sensor was the problem you would have a check engine light on, the fan is operated by the powertrain control module ...

were is the crank sensor located on 2000 crown vic how do I find the crank sensor on the 2000 crown vic Should be under crankshaft puley.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...