02 jeep wrangler 4.0 eng. turn over but will not fire 4.0 2002 engine turns over but will not fire sounds like ignition mod. needs to be replaced
...not start put new module and pick up in the distributor no fire 6 cyl jeep wrangler please help if its equiped with a crank sensor i would chk. that, if crank sensor bad you won't get no spark
...jeep wrangler will not get fire to plugs.put new plug,plug wires,coil, distbr. cap,& rotor.what else would prevent it from starting? a crank sensor tells the coil to fire.are you getting a signal ...
Can't start engine Not getting fire to carburetor, getting fire to distributor on a jeep wrangler 4.2 liter 6 cyl, could it be relay? fuel pump needs replaced or filter.
...jeep wrangler that is cutting out/back fireing I have a 1998 jeep wrangler that is cutting out when I first start out. It is also back fireing badly. I have cleaned the fuel lines, fuel tank, fuel ...
...Jeep Wrangler. I replaced the I have a 1990 Jeep Wrangler. I replaced the starter and the ignition switch and put in a new battery. It still will not start. We got it to crank over by using a screw ...
firing order for a 94 jeep wrangler 2.4l for 2.5L engine, autozone says Firing order 1-3-4-2 --Distributor rotates clockwise
...jeep wrangler and it turns over good but no fire at all I replaced the coil and the camshaft sensor and still no fire not even getting fire to the coil tested the wires from the coil to the computer ...
JEEP WRANGLER. I WASHED THE ENGINE AND NOW IT WILL NOT FIRE. I HAVE REPLACED THE COIL AND COIL WIRE, BUT IT TURNS OVER FINE, BUT IT WILL NOT FIRE. ANY SUGESTIONS? Check and test fuses underhodd (Power
Question about 2010 Wrangler Sport
...order for a 2010 jeep wrangler sport old post 123456 3.8L my guess you mean coil pack wiring. for sure. fiddling cam parts? ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions