Questions & Answers for: install turn signal light 2008

2008 Lucerne won't start. Everything seems good; starter runs, motor turns over, lights come on and are bright, but engine won't engage to run. Need troubleshooting hints. check fuel presure if ...

2008 Buick Lucerne...water in spare tire compartment to fix this problem with my 2007 buick lucerne I had to take off the bumper and then remove the old seal on the body under this bumper and reseal ...

...signal doesn't flash. Removed bulb and tested it for continuity and tested good. installed new bulb that tested good but no flash. The light body doesn't need to be grounded does it.there is no ...

...2008 Buick lucerne Installed new headlight asembly THERE IS USUALLY A TINY SCREW AT THE BOTTOM OF THE HEAD LIGHT TO UDJUST IT. YOU MAY HAVE TO GET A MANUAL ON LINE TO FIND OUT IF YOURS HAS SUCH A ...

turning lights quit turning lights and hazard lights quit,fuses ok The body control module may have failed. It contains logic that controls turn signal and hazard operation.

...turn signal. I am having difficulty getting the new glass mirror off of the housing (which is black). I watched a video and it showed taking the whole door panel off and I do not have that skill set. ...

...synthetic and heard through the driver door speaker from the BCM computer module. Where is the flasher relay located on a 2011 Buick Lucerne Where is the turn signal flasher on the 2008 Buick ...

2008 Buick Lucerne passenger side tail lights lamp won't come on. Backup light will come on and the brake light will illuminate when brake pedal is pressed. Turn signal ?

...2008 buick lucerne p0420 code and trunk won't open unrelated problems Code issue The P0420 code in a Buick Lucerne will often be thrown one of your oxygen sensors are not functioning properly. ...

...2008 Buick Lucerne and my lighter ports don't work? I have looked and can't find if it's a fuse or even what the fuse is supposed to be anything helps! '"Lighter Ports"? You mean accessory power ...